Not sure if the modertors of the BMFA Site will remove this listing as it refers to model boats produced using a 3D printer, I first produced these two racing boats and have since gone onto print 3 2metre gliders .
The boats were just proof of concept and to become familiar with the printer setup etc.
The hulls are complete , have never been in the water , are equipped with jet tube propulsion systems fully ball raced prop shaft and 30 mm / 40 mm dia brushless motors , universal drive couplings and esc’s
Files came from Thingiverse.com.
Hulls are 600mm long beam 200mm One hull is printed in green, the other is in red,white and Blue. Lots of PLA used!!
Looking for £45 each posted

• Listing ID: 151449
• County: Sоuth Yоrkѕhіrе

1. Check all listings by this user
2. Add to favourites
3. Report abuse